Installation; Prior To Installation; Flush Installation Of Cooktop - bora PC 32-000 Instrucciones De Montaje Y De Uso

Installation

Prior to installation

■ The built-in cooktops are designed for integration into the kitchen worktop with
suitable cut-out. The associated control unit is built into the bottom cabinet
front cover.
■ The appliance must be installed and connected to the power supply according
to the instructions in this manual. All installation work must be carried out by an
approved installer/electrician.
■ Dispose of the packaging material according to the applicable statutory
regulations.

Flush installation of cooktop

The distance between the cut-out edge and the rear and side walls must be
minimum 50 mm.
PC 3B-000
For comfortable use of the cooktop, we recommend keeping a distance of
minimum 100 mm between the cut-out edge and the side wall.
For installation in built-in kitchen units, ensure that the plastic or veneer of the
■
units is applied with heat-resistant adhesive as it might otherwise become
loose or deformed, especially at the edges.
Seal the exposed cut-out edge with a sealant such as
■
370
374
R5
cut-out
dimensions
346 x 516
silicone.
14
5