Holmatro PSP40 Manual página 43

• Short-circuit
• Over temperature
3.10 Accessories
3.10.1 Accessories Pentheon system
/i
Description
Battery pack
Battery charger
Mains connector
On-tool charge cable
Daisy chain power cable
3.10.2 Tool specific accessories
/i
Description
spreading tip, set
cutting tip, set
pulling attachment, set
pulling chains, set
pulling chains set, in case
accessories set, in case
3.10.3 Attaching pulling accessories
Refer to Fig. 8.
Pulling accessories (pulling attachments and pulling chains) make it possible to use the tool for pulling.
The pulling attachments must be placed on the spreading arms, instead of the spreading tips. The
pulling attachments may only be used in combination with the corresponding set of pulling chains.
These pulling chains consist of two parts, each with a shortening hook that only grabs the chain. The
chains are 1.5 m and 3 m long respectively.
WARNING
The pulling accessories are intended solely for the horizontal movement of loads.
Hoisting is not permitted with these pulling accessories.
• Make sure that the spreading arms are slightly open.
• Press the lock pin (A) at the bottom and the top.
• Remove the spreading tip (B).
• Push the pulling attachment (D) onto the spreading arm (C).
PSP40
model plug type
PBPA287
PBCH1 AC-EU
PBCH2 AC-US
PBCH3 DC worldwide
PBCH4 AC-JP
PBCH5 AC-UK
PMC1 EU
PMC2 US
PMC4 JP
PMC5 UK
POTC1 worldwide
DCPC1 worldwide
PSP40
150.006.472
150.006.466
150.182.274
150.582.152
150.582.021
150.182.288
916.400.097_002
151.000.583
151.000.629
151.000.742
151.000.632
151.000.630
151.000.631
151.000.633
151.000.743
151.000.634
151.000.635
151.000.499
151.000.503
EN
43