Holmatro PSP40 Manual página 48

EN
Initial opening is insufficient
• Open the spreading arms.
• Place one spreading tip in the opening.
• Close the spreading arms until the material is clamped.
• Bend the clamped material out of the way.
• Repeat this procedure until there is sufficient space to place both spreading tips.
• Force the parts apart by opening the spreading arms.
No initial opening
• Use a different tool or accessory to make an opening.
• Continue with the steps above, depending on the opening created.
6.3.4 Cutting
CAUTION
Make sure that the cutting tips have been properly attached to the spreading arms.
The maximum thickness of the material to be cut is 4 mm.
• Close the spreading arms completely.
• Push the cutting tips into the material to be cut.
• Open the spreading arms so that the cutting tips cut the material.
6.3.5 Pulling
WARNING
The pulling accessories are intended solely for the horizontal movement of loads.
Hoisting is not permitted with these accessories.
WARNING
Make sure that the load is always supported from underneath. Continuously check the
behaviour of the load. Make sure that the tool can move freely during pulling and always
remains in a straight line between both pulling attachments.
• Fully open the spreading arms.
• Correctly place the pulling attachments, so that the shortening hooks point with their openings up.
• Attach the pulling chains to the objects so that they cannot slip off.
• Pull the chains tight and hook them to the pulling attachments.
• Close the spreading arms.
6.3.6 Squeezing
CAUTION
Make sure that the spreading tips have been properly attached to the spreading arms.
• Open the spreading arms.
• Place the spreading tips over the object to be squeezed.
• Close the spreading arms.
6.3.7 Maximum force indicator
Refer to 3.4, 2.
48 916.400.097_002 PSP40