Holmatro PSP40 Manual página 44

EN
• Make sure the openings of the shortening hooks do not point down.
• Check that the pulling attachment is properly locked by the lock pin.
• Attach the pulling chain to the pulling attachment.
• Repeat the action for the second pulling attachment.
3.10.4 Attaching spreading tips
See Fig. 9.
Two spreading tips are delivered as a standard with the spreader. Spare spreading tips can be ordered
if desired.
To replace the default spreading tips by the spare spreading tips:
• Make sure that the spreading arms are slightly open.
• Press the lock pin (A) at the bottom and the top.
• Remove the spreading tip (B).
• Push the new spreading tip onto the spreading arm (C).
• Check that the spreading tip is properly locked by the lock pin.
• Repeat the action for the second spreading tip.
3.10.5 Attaching cutting tips
See Fig. 10.
Cutting tips make it possible to use the spreader for cutting steel plate (St37) not thicker than 4 mm.
Cutting tips can be ordered if desired.The cutting tips are placed on the spreading arms instead of the
spreading tips.
• Make sure that the spreading arms are slightly open.
• Press the lock pin (A) at the bottom and the top.
• Remove the spreading tip (B).
• Push the cutting tip (D) onto the spreading arm (C).
• Check that the cutting tip is properly locked by the lock pin.
• Repeat the action for the second cutting tip.
4 Preparation for first use
4.1 General
• Examine the equipment for completeness and damage. Do not use the equipment if it is damaged;
in that case contact the Holmatro dealer.
• Examine the operation of the deadman's handle. when released, the deadman's handle must return
to the neutral position.
• Before first use, charge the battery pack fully. Refer to section 5.2.
• Put the battery pack in the battery pack fitting / adapter fitting until the battery pack locks.
• Examine the battery pack to make sure that the lock mechanism operates correctly.
44 916.400.097_002 PSP40