Grounding Instructions - Ingersoll Rand Insight IC1G Manual Del Usuario

Precautionary Information
•
Do not modify this product, safety devices, or accessories.
Unauthorized modifications may result in electric shock, fire
or personal injury.
•
Do not use this product for purposes other than those
recommended. Personal injury may result.
•
Disconnect power and lockout/tagout machine prior to
removal, insertion or servicing of any component or
module within this product. Failure to follow instructions
can result in risk of electric shock and personal injury.
•
Install this product to a vertical structure capable of
safely supporting its total weight. Failure to follow
installation instructions properly can result in structure
collapse and personal injury.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN ELECTRIC
THE CONTROLLER MUST BE EARTH GROUNDED. The controller is equipped with a three prong plug and cable. Comply with all
local electrical codes for connecting to Power Supply. The Power Supply must be within voltage and frequency requirements as specified
below. DO NOT use the controller on a 2-prong plug outlet with an adapter. Always check that your ground is operating properly on the
outlet by a qualified electrician before using the controller.
The three conductors of the mains lead attached to this apparatus
are identified with color as shown in the table, together with the
matching terminal plug. When connecting the mains lead to a
plug, be sure to connect each conductor to the correct terminal as
indicated.
•
Do not allow chemicals such as acetone benzene, thinner,
ketone, trichloroethylene to come in contact with the
housing, as damage will result.
© Ingersoll-Rand Company 2004

GROUNDING INSTRUCTIONS

SHOCK, FIRE AND/OR SERIOUS PERSONAL INJURY.
Grounding Specifications
Voltage Requirement (Single Phase)
Model
Identification
Volts, Hertz
115, 50/60
IC1G
230, 50/60
115, 50/60
IC2G
230, 50/60
THIS APPARATUS MUST BE EARTH GROUNDED
•
Verify the operation of the Earth Leakage Circuit
Breaker (ELCB) once per month with the test button. A
malfunctioning ELCB can result in risk of electric shock or
injury.
•
Do not attach or place external loads on any part of the
Controller. Loading may cause hinge or mounting failure
and result in personal injury.
•
Replace battery with the same or equivalent type
recommended by the battery manufacturer. Observe
correct polarity when installing battery. Dispose of used
batteries according to battery manufacturer's
instructions. Failure to follow instructions could result in
personal injury.
WARNING
Amperage
EU WIRING
WARNING
MAINS LEAD
Conductor
Live
Neutral
Grounding
CAUTION
•
Keep the exterior of the unit clean and dry.
Page 2
16 Amps
8 Amps
20 Amps
13 Amps
PLUG
Mark on the Matching
Color
Terminal
Brown Red or letter L
Blue Black or letter N
Green, Green-Yellow
Green-Yellow
letter G or symbol ⊥