Insight Set-Up - Ingersoll Rand Insight IC1G Manual Del Usuario

Installation
Before starting the Insight IC Fastening System with Graphics Display for the first time, you must go
through the following checklist and verify that all of the steps have been completed. If in doubt about any
aspect of this checklist, contact Ingersoll-Rand.
• The Insight controller enclosure is vertical, level, and securely mounted.
• For every spindle location that will be used there is a spindle attached to that location in the connector
panel (located on the controller's right side), and each spindle connector is locked down.
• If the Insight is equipped for attaching external devices (printers, computers, etc.), the proper devices
have been attached to the appropriate ports in the connector panel (located on the controller's left
side).
• The main enclosure is closed and locked.
• The AC power cord is plugged into a properly rated electrical circuit. (See the Precautionary
Information at the beginning of this manual.)
Once the above checklist is verified, you are ready to power-up the Insight IC Fastening System with
Graphics Display.
1. Turn the Main Power Switch to On. This switch sends power to the internal Motor Controllers, the
graphics display, and the keypads, but does not send power to the spindle(s) or powerhead.
2. Push the green Spindle Power Switch located on the front panel. The Run Main screen will be
displayed on the graphics display panel, indicating the startup was successful and the Insight IC is
ready to operate.
• When you want to turn the entire Insight system on or off use the Main Power Switch.
• After turning the system off, wait at least five seconds before turning it on again.
• When you want to turn only the spindles on and off use the Spindle Power Switch.
© Ingersoll-Rand Company 2004

INSIGHT SET-UP

Intital Start-up
Page 5