Electrical Connection - Ingersoll Rand Insight IC1G Manual Del Usuario

Bolt the Insight controller enclosure to a suitable surface near the assembly area using the mounting
brackets on the back of the enclosure. See User Manual for dimensions, information on bracket hole
spacing, recommended mounting bolts, door opening clearances, and other mounting information.
• Make sure the mounting is stable, secure, and level.
• Attach the Insight enclosure to a structure capable of safely supporting its total weight. Failure
to follow installation instructions properly can result in structure collapse and personal injury.
• Make sure the Main Power Switch is in the Off position.
In the United States, the Insight controller enclosure comes pre-wired with a power cord and the
appropriate plug. Insight systems sold outside the USA come with a pigtail (cable tail), and the user must
supply the correct power cord connector. Review the electrical circuit information on the Insight's label
(on the right-side panel) and in the specifications table. Verify that your electrical circuit meets the
Insight's power requirements and circuit breaker ratings. Plug the AC power cord into an appropriate
receptacle
• It is the user's responsibility to ensure that the Insight controller is installed and wired by a qualified
electrician.
Attach your Ingersoll-Rand spindles (or powerheads) on the right side of the Insight enclosure. One or
two spindles may be attached. At the end of each spindle's cable is a twist-to-lock multi-pin connector
designated Spindle #1 or Spindle #2. In general, any spindle may be plugged into any spindle connector.
However, you may have preferred locations for the spindles based on the fastening applications. Plug
each tool into the appropriate connector and lock it in place.
There should be a tool attached to each connector. If no tool is present, when the unit is powered up, no
power will be delivered to the empty connector. This is a safety feature. The Insight interprets the lack of
a tool as a tool with a possible ground fault, and does not energize that circuit. If a connector is left empty
and a tool is added at a later time, first turn the Insight Main Power Switch off, wait five seconds, and turn
it back on.
• Never connect a spindle to the Insight Controller with the spindle power switch ON.
© Ingersoll-Rand Company 2004
INSTALLATION
Mounting the Insight Enclosure
WARNING

Electrical Connection

WARNING
Attaching the Spindles
Page 4
Installation