Important - DeVilbiss KB-522 Manual De Operación

E E
Hose connections
Air
Fluid
Maximum Working Pressure
Maximum Air supply pressure
Height
Weight (dry)
Capacity
PARTS IN CONTACT WITH COATING MATERIAL:
Cup
Cup Lid
Lid Seal
Tube
Tube Nut
Check Valves
Pressure Relief Valve
IMPORTANT: To ensure that this equipment
reaches you in first class condition, protective
coatings, rust inhibitors, etc., have been used.
Flush all equipment through with a suitable
solvent before use to remove these agents from
the material passages.
CAUTION: The cup is under pressure.
Disconnect the air supply and release the
pressure in the cup assembly before removing
the cup from the lid assembly or disconnecting
the gun or the material hose. Never allow the cup
to lay on its side or fall over when it contains
material.
Controls (See Figure 1)

Safety Valve (14): The safety valve limits the
maximum air pressure to the cup. If the
safety valve does not work properly, over
pressurisation may occur and cause the cup
to rupture or explode. Occasionally pull the
ring on the safety valve and make sure that it
operates freely. If the valve is stuck or does
not operate smoothly it must be replaced
with a valve having the same rating. Never
attempt to adjust or dismantle the safety
valve.

Regulator (15): Controls the pressure of the
coating material in the cup. To increase the
© 2013 Finishing Brands UK Ltd.
Specification
: 1/4" Universal
: 3/8" Universal
: 2.1 Bar (30 lbf/in2)
: 8.6 Bar (125 lbf/in2)
: 183 mm (7 3/16")
: 1.76 kg (3 lb 14 oz)
: 2 Litres
522
: Aluminium Alloy
: Aluminium Alloy
: Santoprene
: Aluminium Alloy
: Brass Nickel Plated
: Acetal, Brass and S.S
: Brass Nickel Plated
Installation
1. Connect the coating material hose (Fig 2, A)
2. Connect the air hose (B) from the cup outlet
3.
Operation


NOTE: Regularly check that the pressure gauge
is reading correctly. Mix, prepare and filter the
coating material to be sprayed according to the
manufacturer‟s instructions.
522-SS
Stainless Steel
Aluminium Alloy Nickel Plated
Santoprene
Stainless Steel
Stainless Steel
Acetal, Brass and S.S
Brass Nickel Plated
from the cup outlet to the gun.
to the gun.
Connect the air supply hose (C) to a filtered/
regulated air supply and to the cup inlet.
pressure, pull knob out, turn the knob in the
direction of the arrow shown on the knob, to
reduce pressure turn in the opposite
direction. When pressure is set push knob in
to lock.
Pressure Relief Valve (6): Vents the air
pressure in the cup. To open, turn valve
counter-clockwise. CAUTION Do not
unscrew the pressure relief valve (6)
completely when relieving the pressure as it
may have sufficient air pressure to eject the
valve from the lid creating a hazard.
Pressure Gauge (8): Indicates the air
pressure in the cup. Do not attempt to
remove the cup (15), spray gun or coating
material hose if the gauge indicates pressure
in the cup.
6