Broan B5330SS Manual De Instrucciones página 6

6" ROUND
DUCT ELBOW
10. Measure and install 6" round steel ductwork to roof cap or
wall cap and 90 elbow over duct collar on hood. Use duct
o
tape to make all joints secure and air tight.
11. Plug hood power cord into the outlet.
LOWER FLUE MOUNTING BRACKET
LOWER
FLUE
NOTE: 10-ft. ceilings require 10-ft. Flue Extension Model
FXN53SS (purchase separately). Discard the upper flue
supplied with your hood and replace it with the Model
FXN53SS flue extension.
12. Remove the upper flue from inside the lower flue. Install the
lower flue bracket to the lower flue using (2) flue bracket
screws #8 x 3/8", make sure that the slots are at the top.
Remove protective plastic film covering the lower flue only.
Carefully replace the upper flue inside the lower flue.
13. Carefully place both flues into the recessed area of hood
top. Make sure tabs on the lower flue are pointing down and
engage with the slots on the top of the hood.
MODELS B5330SS • B5336SS
UPPER FLUE MOUNTING BRACKET
UPPER
FLUE
14. Slide the upper flue upward until it is aligned with its upper
mounting bracket. The bracket should be inside the flue.
Secure the upper flue to the upper flue mounting bracket
using (2) #8 x 3/8" mounting screws.
15. Remove any protective plastic remaining on hood.
INSTALL THE HOOD
(Vertically Ducted Hoods Only)
1. DO NOT REMOVE the protective plastic film covering the
decorative flue and the hood at this time.
2. Lay the back side of the hood flat on a table. Use a piece of
cardboard to avoid damaging the table or the hood.
3. Attach damper / duct connector to top of hood using (4) #8
x 3/8" Pan Head mounting screws.
4. Remove the grease filters by pushing back the metal latch
tab and tilting filters downward to remove.
5. Carefully rotate hood upright.
LOWER FLUE MOUNTING BRACKET
LOWER
FLUE
NOTE: 10-ft. ceilings require 10-ft. Flue Extension Model
FXN53SS (purchase separately). Discard the upper flue
supplied with your hood and replace it with the Model
FXN53SS flue extension.
6. Remove the upper flue from inside the lower flue. Install the
lower flue bracket to the lower flue using (2) flue bracket
screws #8 x 3/8", make sure that the slots are at the top.
Remove protective plastic film covering both flues. Carefully
replace the upper flue inside the lower flue.
7. Carefully place both flues into the recessed area of hood
top. Make sure tabs on the lower flue are pointing down and
engage with the slots on the top of the hood.
Page 6