ResMed S8 Escape II Guia Del Usuario página 19

Note: At a fixed rate of supplemental oxygen flow, the inhaled oxygen
concentration will vary, depending on where the oxygen is introduced, the
pressure settings, patient breathing pattern, mask selection, and leak rate.
Do not use the S8 Escape II if there are obvious external defects or
•
unexplained changes in performance.
Do not open the S8 Escape II case. There are no user serviceable parts
•
inside. Repairs and internal servicing should only be performed by an
authorized service agent.
Explosion hazard—do not use in the vicinity of flammable anesthetics.
•
Cautions
At low pressures, the flow through the exhalation ports of your mask may not
•
clear all exhaled gas from the tubing. Some rebreathing may occur.
The airflow for breathing produced by this device can be as much as 11ºF
•
(6ºC) higher than the temperature of the room. Caution should be exercised if
the room temperature is warmer than 90ºF (32ºC).
When AC mains power (100–240V AC) is not available, always use a ResMed
•
DC-12 converter. (The DC-12 converter is available as an optional accessory. It
is not supplied with all models.)
Note:
The above are general warnings and cautions. Specific warnings,
cautions, and notes appear with the relevant instructions in the manual.
General Warnings and Cautions 15