Aprimatic LINEARE Instrucciones Para La Instalación página 13

3.1. INSTALLATION
For a perfect installation of the product, follow the
instructions below.
- Cut the adhesive white paper template provided
along the broken line.
- Use part 1 to mark the position of the front atta-
chment and part 2 for the position of the operator
support.
- Trace the middle line of frame A, position both
adhesive templates (1, 2) taking as reference the
median lines A1, then drill as indicated in the tem-
plates.
- Fix the front attachment B with screws suitable
for the frame material (for aluminium frames, use
self-threading screws 4.8x16 UNI6954 or similar;
always ensure the installation is done according
to the good installation practices).
- Fix the front bracket C to support the operator.
- Ensure the height of the bracket is such that the
operator is perpendicular to the frame.
- Screw the front eyelet pin D on rack E. Adjust
the protrusion of pin D and tighten with lock nut F.
Position inserts G into the special guides on the
operator.
- Fix the LINEARE operator H to the front bracket
C using the pins provided.
- Then fi x the front eyelet pin to the attachment in
front of frame B.
!
Warning
During the motion, do not touch the rack and
keep clear of the working range of the closing
device.
Ensure the LINEARE operator can reach the
triggering positions of the limit switch without
troubles.
Absolutely avoid to mount the appliance fol-
lowing procedures other than those indicated
in this manual.
Do not use this template for "DUO" applica-
tions.
Information
The LINEARE operator is supplied with limit
switch set to close position.
Lineare.indd
R
13
DIMA
1
2
A
A1
G
B
C
H
13
3
Installation
Linea Tratteggiata
A1
B
1
C
2
G
F
D
E
25/07/2001, 15.23