Electrical Connection; Wiring Diagram; Final Operations - Aprimatic LINEARE Instrucciones Para La Instalación

3
Installation
3.2.

ELECTRICAL CONNECTION

For the electrical connection of the LINEARE operator, it is important to check the correct cross-section
of the power cables that must be dimensioned suitably in relation to the absorption of the operator and
the length of the connection.
Operator with 24 VDC power supply ± 15%
Cable 1 = Blue (+ open, - closed)
Cable 2 = Brown
!
Warning
During installation and maintenance, turn the power off.
The window can also be closed and opened by hand by disconnecting the motor-drive operator
from the frame.
Caution
For the safety of the installation, use an unstable button (dead man's button) or a timed power
supply for the time of use of the appliance. For applications installed at less than 2.5 m from the
ground, use a dead man's control logic.
3.3.

FINAL OPERATIONS

When the installation of the LINEARE operator has been completed, the technical installer must apply
an adhesive plate with the inscription " WARNING - MOVING GEARS " close to the device to signal the
presence of the device in a clear way.
If necessary, lubricate the device with marine or graphitised grease.
In the case of installations close to the coast, lubricate the rack with marine or graphitised grease every
six months.
Lineare.indd

WIRING DIAGRAM

1
( - ) + 24 V
2
( + ) - 24 V
14
14
R
25/07/2001, 15.23