Starting Procedure - Maruyama Mist Duster MD 830 Manual Del Propietario Y Operador

OPERATING INSTRUCTIONS

STARTING PROCEDURE

Step#1) Move the "Mist cock" to the closed
position.
Step#2) Pour chemical into the chemical
tank.
Step#3) Close the lib tightly.
PRIMER
BULB
FUEL
RETURN LINE
STEP #4) Pump the "PRIMER BULB" under
of the carburetor until fuel can be
seen flowing through the "FUEL-
RETURN LINE".
If a MARUYAMA engine fails to start after following the above procedures, contact an authorized
MARUYAMA dealer.
English
STEP #5) Move the "CHOKE LEVER" fully up
Do not spill
the liquid
STEP #6) Set the throttle lever at 1/2 speed.
Close the
cover tightly
CAUTION! Pull the "STARTER GRIP" briskly
to start the engine.
NOTE: Only short pulls are necessary. Never
pull the starter cord to its fullest extension.
Never let go of the starter grip until it is at the
fully returned position.
STEP #7) Warming up the engine. When the
— 11 —
CLOSE
CHOKE
LEVER
OPEN
ward to the closed position. If the
engine is already warm, only a
partial or open (no choke) choke
setting may be required.
HIGH SPEED
IDLE SPEED
STOP
STARTER GRIP
OPEN
engine has started, slowly move the
"CHOKE LEVER" fully upward to the
open position. Allow the engine to
"WARM-UP" at less than 1/2 speed.