Spark Plug; Fuel Filter - Maruyama Mist Duster MD 830 Manual Del Propietario Y Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SPARK PLUG

The spark plug should be removed from the engine and checked
after each fifty (50) hours of use. The tips can be cleaned with a
stiff brush. Adjust the gap to 0.031 - 0.035 inches (see sketch).
Replace the spark plug if it is oil-fouled or damaged.
CAUTION!
The correct torque for the spark plug is 10 - 12 ft. lbs. Do not over-
tighten.

FUEL FILTER

The fuel filter should be cleaned and inspected for damage after each twenty (20) hours of use.
The fuel filter is attached to the fuel pick-up tube inside the fuel tank. Loosen the clamp and take out
the fuel filter.
FUEL TUBE
To clean the fuel filter, remove it from the fuel tube and wash it with safety solvent. Inspect and clean
the fuel tank before re-installing the fuel filter.
Always replace a defective fuel filter.
COOLING FINS
Free passage of air flow through the cylinder cooling fins is required to prevent poor engine
performance and shortened engine life. Regularly check and clean all debris from the cooling fins by
removing the engine cover (see sketch).
COOLING FINS
MUFFLER AND EXHAUST PORTS
The muffler should be removed and serviced after each one fifty (50) hours of use. At the same time,
the exhaust ports should be cleaned and inspected. An AUTHORIZED MARUYAMA DEALER should
be contacted for this service.
CLAMP
GROMMET
FUEL FILTER
ENGINE COVER
— 14 —
TIPS
PROPER GAP
0.031 - 0.035 IN.
WEIGHT
FUEL FILTER
English

Publicidad

Tabla de contenido
loading

Tabla de contenido