Limits Of Use; Installation; Instructions For The User; Electric Connection - Gastrodomus FAIRXL66 Manual De Instrucciones

THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN) WITH REDUCED
PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS
THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE BY A
PERSON RESPONSIBLE FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH THE APPLIANCE

LIMITS OF USE

This oven has been designed and manufactured exclusively for the destination of use described above,
therefore, any other type of use is strictly forbidden in order to assure, at any time, the safety of the
authorized operators, as well as the efficiency of the oven itself.

INSTALLATION

INSTRUCTIONS FOR THE USER

The place where the oven is installed must have the following enviromental characteristics:
 To be dry;
 Water sources at safe distance;
 Adequate ventilation and lighting corresponding to hygene and security rules following the existing
laws.
THE OVEN MUST NOT BE INSTELLED IN PROXIMITY OF THE INFLAMMABLE
MATERIALS (WOODS, PLASTIC, COMBUSTIBLE, GAS, ETC.). AVOID THE CONTACT
OF INFLAMMABLE OBJECTS WITH THE HOT SURFACES OF THE OVEN. ALWAYS
ASSURE THE SAFETY FIREPROOF CONDITIONS. MAINTAIN A FREE SPACE AROUND
THE OVEN OF AT LEAST 30 CM.
Verify that the electrical set-up corresponds with the numbers of the techincal characteristics on the small
plate at the back of the oven. The characteristics of the electric socket must be compatible with the plug
installed on the cable.

ELECTRIC CONNECTION

THE ELECTRIC CONNECTION OF THE OVEN TO THE MAINS MUST BE
COMPULSORILY AND EXCLUSIVELY PERFORMED BY AN AUTHORIZED TECHNICIAN
(ELECTRICIAN) SATISFYING THE TECHNICAL AND PROFESSIONAL REQUIREMENTS
STATED BY THE REGULATIONS IN FORCE IN THE COUNTRY OF USE OF THE OVEN,
WHO MUST ISSUE A DECLARATION OF CONFORMITY FOR THE INTERVENTION
PERFORMED.
THE ELECTRIC CONNECTION OF THE OVEN TO THE MAINS MUST BE
COMPULSORILY AND EXCLUSIVELY PERFORMED BY AN AUTHORIZED TECHNICIAN
(ELECTRICIAN) SATISFYING THE TECHNICAL AND PROFESSIONAL REQUIREMENTS
STATED BY THE REGULATIONS IN FORCE IN THE COUNTRY OF USE OF THE OVEN,
WHO MUST ISSUE A DECLARATION OF CONFORMITY FOR THE INTERVENTION
PERFORMED.
To connect the machine to the electric network it is necessary to proceed as follows:
1. Connect to the wires to the terminals L1—L2—L3—N —
mm² unsheathed with ferule;
2. Put together the other end of the cable and a plug, which is normalised and polarised (the
distinction between phase and neutral must be unequivocal.
3. To connect the oven to 230 V single phase is sufficient to make a bridge between L1-L2-L3 with
the special plates present in the terminal box.
of power cord type H07RNF 3G X "x"
12