Alarm Settings - Bresser ClimaTemp FSX Manual De Instrucciones

8. NOTICE! To restore the automatic time setting,
press the SNOOZE/LIGHT button again for 8
seconds. The reception symbol for the radio-con-
trolled watch reappears in the display.

11 Alarm settings

1. In normal display mode, press the TIME button several
times to display the Alarm time AL1 or AL2.
2. Press ALARM button for approx. 3 seconds to enter the
alarm time setting mode.
3. Digits to be set are flashing.
4. Press CH/UP or 12/24/DOWN button to change the
value.
5. Press ALARM button to confirm and continue to the
next setting.
6. Settings order: hours > minutes > ice alert on/off
NOTICE! If ice alert is enabled (on), the alarm will sound
30 seconds before the set alarm time if the temperature
is -3° or below.
7. Finally press the ALARM button to save the settings
and exit the setting mode. Alarm will be activated auto-
matically. The
8. In normal display mode, press the ALARM button sev-
eral times to enable alarm time AL1, AL2 or both. If the
alarm is enabled, the corresponding symbol will be dis-
played ( 1, 2 or 1 2).
symbol will be displayed.
13 / 108