Innotek ULTRASMART IUC-4100E Manual Del Usuario página 5

Quick Start Guide
Step 5
Charge Collar
Choose a location close to a door that you and your dog use regularly
and plug in the wall charger. Position the collar in the charging cradle.
The collar fits in the cradle with the collar light to your left and with
the contacts that touch your dog's skin facing down.The collar's light
glows red while charging, green when charging is complete.
Step 6
Test Your Fence
Set the FIELD WIDTH ADJUSTMENT knob
inside the transmitter to the 9 o'clock
position. Hold the supplied test light across
the skin contacts and walk the dog's collar
up to the fence wire. Listen for the warning
tone and look for the test light to illuminate. You should receive a signal 2.5 to 4M feet from the wire. To
increase field width, rotate the adjustment knob clockwise. Test the collar in different places around the
fenced area to verify the range is consistent.
Step 7
Bury Fence Wire
Dig a trench about 7.5cm deep, using a
straight-edged spade or gas-powered
edger. Digging the trench at an angle helps
keep the wire in the ground where you
place it. Place training flags at edge of
selected boundary field where the warning tone is first heard, NOT at the wire.
Step 8
Train Your Dog
Watch the training DVD and follow the training steps outlined in the separate
Training and Troubleshooting Guide. Your dog may show good initial response to
the training; be sure to follow the training procedure for several weeks. The
convenience that your new fence offers plus the added safety for your dog and
family are well worth the time invested.
(continued)
1. Field Width
Adjustment Control
3
IUC-4100E & IUC-5100E
collar light
Page 8
Page 8
Inside Fencing Field
Page 9