Peg-Perego CORRAL T-REX Empleo Y Manutencion página 8

IF ELECTROLYTE IS INJESTED
Rinse your mouth and spit.
See a physician at once.
DISPOSAL OF BATTERIES
Help protect the environment!
Do not throw used batteries in your regular, house
hold trash.
Dispose of the old batteries in an approved
dumping station; contact your local environmental
protection agency office for further information.
VEHICLE MAINTENANCE AND SAFETY
This product complies with European Safety
Standards for toys. It does not comply with
standards for road transport and therefore cannot
be used on public roads.
MAINTENANCE AND CARE
• Regularly check the conditions of the vehicle,
particularly the electrical system, the plug
connections, the covering caps and the charger. In
case of fault, do not try to use the vehicle and the
charger. For repair use only original PEG PEREGO's
spare parts.
• PEG PEREGO assumes no liability if the electrical
system is tampered with.
• Do not leave vehicle or batteries near sources of
heat such as radiators, stoves, fireplaces, etc.
• Protect vehicle from water, rain, snow, etc. Do not
ride in loose sand or mud as these substances will
cause premature failure of switches, motors and
gears.
• When operating in overload conditions, such as
soft deep sand, mud or rough uneven terrain, the
overload circuit breaker will automatically
disconnect the power. After 10 or more
seconds,the circuit breaker will automatically
reset, howevere you must eliminate overload
conditions to resume normal driving.
• Periodically lubricate (with a light weight oil)
moving parts, such as wheel bearings, steering
linkages, where they rotate or touch one another.
• The vehicle's surface can be cleaned with a
dampcloth. Do not use abrasive cleaners.
• The cleaning must be carried out by adults only.
• Never disassemble the vehicles mechanisms or
motors unless authorized by PEG PEREGO.
Recargeable battery 12V 8Ah sealed lead-acid
battery.
Two 140W motors
WEEE DIRECTIVE (EU only)
• At the end of its useful life, this product is classed
as Waste Electrical and Electronic Equipment
(WEEE) and must therefore not be disposed of as
urban waste but instead must be taken to a
designated separated waste collection facility.
• Take the refuse to the relevant designated
collection facility.
• The presence of dangerous substances contained
in the electrical components of this product
represents a potential source of danger for human
health and for the environment if the product is
not correctly disposed of.
• The barred dustbin indicates that the product
must be subject to sorted waste collection.
SAFETY
WARNING! THE CAR MUST BE USED UNDER ADULT
SUPERVISION.
• Not suitable for children under the age of 36
months. The small pieces could be swallowed or
inhaled.
• Never use the vehicle on steep slopes or near
steps or stairs. This vehicle is not suitable for use
on public highways.
• Children should always wear shoes when riding in
or driving a ride-in/ride-on vehicle.
• Do not allow children to place their hands, feet or
any part of their body, clothing or other articles
near the moving parts while vehicle is in
operation.
• Do not allow the electrical components, motors,
wiring, switches of your motorized vehicle to
become wet and never wash it with a hose.
• Never use gasoline or other flammable
substances near the vehicle.
• The vehicle is constructed just for one child.
RULES FOR SAFE DRIVING
DON'T STOP THE FUN: always have freshly charged,
back-up batteries on hand.
For your child's safety: please read and follow all
instructions below before operating.
• ATTENTION:
Make sure that all locking bolts are correctly
tightened.
2nd SPEED
Initially we suggest using only the 1st speed and
the reverse gear. Before moving into 2nd speed be
sure that the child has become familiar with
operating the vehicle.
• 1ST SPEED slow speed (beginner drivers):
With both hands on the handlebars, press down
on the accelerator pedal; the vehicle goes forward
at 3,2 Km/h 2 MPH.
• 2ND SPEED fast speed (exsperienced drivers):
With both hands on the handlebars, press down
on the accelerator pedal; the vehicle goes forward
at 6,5 Km/h 4 MPH.
• REVERSE:
Place the other hand on the handlebars on press
your foot down on the accelerator. The vehicle
revereses at 3,2 Km/h 2 MPH.
• BRAKE:
The electric braking system stops the vehicle
automatically when your child lifts his foot off the
pedal.
Teach your child the proper use of this vehicle for a
safe and fun play time.
• Before starting be sure that the way is free from
people and objects.
• Drive with both hands on the handlebar and keep
your eyes on the road at all times.
• Stop in time to avoid accidents.
• Use the 2nd speed only after your child has the
maturity and the reflexes to operatye vehicle
safety.
• CAUTION! In first gear, the vehicle as a
differential effect like real cars: on smooth
terrain and with one child, the two wheels may
turn at different speeds, resulting in possible
sliding/deceleration.
• CAUTION! When operating in overload
conditions, such as soft deep sand, mud or
rough uneven terrain, the overload circuit
breaker will automatically disconnect the
power. After 10 or more seconds,the circuit
breaker will automatically reset, howevere you
must eliminate overload conditions to resume
normal driving.
PROBLEMS?
IF THE VEHICLE DOES NOT OPERATE?
• Check that all the plugs are properly connected.
• Check the accelerator switch, if vehicle runs
replace switch.
• Check that the battery is connected to the
electrical system.
IF THERE IS NO POWER?
• Fully recharge the batteries. If the problem
persists, check with an Authorized PEG PEREGO
Service Center.
FRANÇAIS
• PEG PEREGO® vous remercie de votre confiance et
vous félicite d'avoir choisi ce produit. Depuis plus
de 50 ans, PEG PEREGO emmène en promenade les
enfants: à peine nés, avec ses fameux landaus et
poussettes et plus tard, avec ses fantastiques
véhicules à pédales et à batterie.
• Lire attentivement ce manuel d'instructions pour
se familiariser avec l'utilisation du modele et
enseigner a l'enfant a conduire prudemment tout
en s'amusant. Garder ce manuel pour toute
necessite future.
• Nos jouets répondent aux conditions de sécurité
prévues, par le Conseil de la EEC, par le "U.S.
Consumer Toy Safety Specification" et approuvés
par le T.Ü.V. et par le I.I.S.G. Istituto Italiano Sicurezza
Giocattoli.
Peg Perego S.p.A. bénéficie de la
certification ISO 9001.
La certification assure aux clients et
aux consommateurs une garantie de
transparence et de confiance dans la
façon dont travaille l'entreprise.
• Peg Perego pourra apporter à tout moment des
modifications aux modéles décrits dans cette
publication, pour des raison de nature technique ou
commerciale.
Ans 3-8
SERVICE D'ASSISTANCE
PEG PEREGO offre un service d'assistance après-
vente, directement ou à travers un réseau de
centres d'assistance autorisés pour les éventuelles
réparations ou pour le remplacement et la vente de
pièces de recharge d'origine. La liste des centres
d'assistance est fournie sur la dernière page de ce
manuel d'instructions.
Peg Perego est à la disposition de ses
consommateurs pour satisfaire au mieux toutes
leurs exigences. À cette fin, connaître l'avis de nos
clients est pour nous extrêmement important et
précieux. Nous vous saurions donc gré, après avoir
utilisé l'un de nos produits, de bien vouloir remplir
le QUESTIONNAIRE SATISFACTION DU
CONSOMMATEUR que vous trouverez sur Internet à
l'adresse suivante:"www.pegperego.com" , et de
nous faire vos éventuelles observations ou
suggestions.
INSTRUCTIONS DE MONTAGE
ASSEMBLAGE PAR UN ADULTE REQUIS. PRENDRE
GARDE AU MOMENT DE DEBALLER CAR LES
COMPOSANTES A ASSEMBLER PEUVENT
COMPORTER UN DANGER DE PETITES PIECES OU DE
BORDS TRANCHANTS.
LA BATTERIE EST DEJA EN PLACE A L'INTERIEUR DU
VEHICULE.
MONTAGE
1 • Insérer le levier de vitesse dans le logement
prévu à cet effet, jusqu'au déclic.
2 • Positionner le pare-chocs sur l'avant du cadre.
Soulever.
3 • Fixer le pare-chocs.
4 • Positionner et fixer le tableau de bord.
5 • Insérer la poignée sur le guidon.
6 • Fixer à l'aide de la vis. Procéder de la même
façon avec la seconde poignée.
7 • Mettre en place le bloc guidon sur le cadre.
Fixer le guidon comme indiqué sur la figure.
8 • Installer l'ailette pare-boue en veillant à ce que
les 2 crochets puis le taquet s'insèrent
complètement.
9 • Insérer la vis dans le taquet et visser l'ailette.
Faire de même pour l'autre ailette.
10 • Pour positionner le tuyau d'échappement,
insérer la languette A dans le trou du fond.
11 • Serrer le tuyau d'échappement avec la vis
fournie. Exécuter les mêmes opérations pour
l'autre tube.
12 • Insérer l'antenne dans l'orifice prévu à cet effet
et l'enfoncer.
13 • Monter en faisant pression les 4 écrous
enjoliveurs, en veillant à ce que les languettes
s'insèrent correctement dans les logements de
la jante.
14 • Dévisser la vis de fixation de la selle.
15 • Faire pression sur l'arrière de la carrosserie pour