Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
PROBLEM
POSSIBLE
CAUSE
A light flash
The SKIN
is not emit-
CONTACT
ted when
SENSORS are
I press the
not in full con-
FLASH
tact with the
BUTTON.
skin.
You have not
waited enough
time between
flashes for the
Remington iLIGHT
Ultra Face & Body
bulb to recover.
The
REPLACEMENT
CARTRIDGE
has flashed
65,000 times
and needs to be
replaced. You
should see the
Light Bulb flash-
ing YELLOW.
WHAT YOU SHOULD DO
Check that both SKIN CONTACT SENSORS are
touching your skin. The Remington iLIGHT Ultra
Face & Body device won't work unless it's flat
against your skin. See steps 2b-2f in Figure 5
for this situation.
The Remington iLIGHT Ultra Face & Body device
requires 3 seconds to recover between flashes.
When the device is ready to flash (and assuming
the SKIN CONTACT SENSORS are flush against
the skin), the device will emit three "BEEPS" to
confirm that it is ready to flash. See steps 2b-2f
in Figure 5 for this situation.
Make sure that the CARTRIDGE STATUS INDICATOR
DISPLAY is either solid green or solid yellow. If
it is flashing yellow, disconnect the Remington
iLIGHT Ultra Face & Body device and replace the
REPLACEMENT CARTRIDGE. Refer to "Replacing the
REPLACEMENT CARTRIDGE" in Figure 7.
42
Publicidad
Tabla de contenido
