Quick Start Guide - Samson Stage v466 Manual De Usuario

Quick Start Guide

Follow these basic procedures for setting up and using your Stage v466 Series Wireless System.
1. Connect the SR466 receiver power
adaptor to the rear panel DC input, and
then to an electrical outlet.
2. Connect the receiver's appropriate ¼" outputs to the input of a mixer, stereo, karaoke machine,
or any other line level input (see below). If there is a limited number of input channels,
connect the XLR output to the XLR input of a mixer for a combined, mixed, output of all four
receivers.
Use the two included ¼" to ¼" cables to
connect the SR466 receiver to a mixer. Each
output will send a mixed signal of a pair of
receivers, Channel 1 & 2 and Channel 3 &
4. For individual control of each receiver,
connect four ¼" to ¼" cables from the
SR466 receiver to four input channels on
a mixer.
Use the included ¼" to ¼" cables to
connect the SR466 receiver to karaoke
machine.
Stage v466: Quad Vocal Wireless System
9