Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Check that air conditioner is tilted back about 1/4" (tilted about 2º to 4º downward to the outside, see
10
FIG. 15A & FIG. 15B). After proper installation, condensate should not drain from the overflow drain hole during
normal use, correct the slope otherwise.
FIG. 15A
H
N I
S
D I
E
H
about
1/4"
Wooden Window
Trim the weather seal
11
peel off the protective backing and plug any gaps if needed
as shown FIG.16.
Removing the air conditioner From Window
Turn the air conditioner off, and disconnect power cord.
Remove sash seal from between windows, and unscrew sash lock.
Remove screws installed through frame and framelock.
Remove the insulation panel and close (slide) side panels into frame.
Keeping a firm grip on air conditioner, raise sash and
carefully remove.
Be careful not to spill any condensate water while lifting
unit from window. Store parts WITH air conditioner.
2º to 4º
O
U
T
S
D I
E
Bottom Rail
with a proper length,
FIG. 15B
H
INSIDE
about 1/4"
H1
Vinyl-Clad Window
2º to 4º
OUTSIDE
Bottom Rail
FIG. 16
5
Publicidad
