Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Place the product on a solid, level surface.
This product is not a toy and should only be
used under adult supervision.
Check the product for damage or wear before
every use.
Never use the product close to an open flame.
We recommend that two people assemble the
product to avoid injury or damage to the product.
Do not let go of the handle
released it from the fixing post
it when the screen is securely in the cassette
Carelessly letting go of the handle
cause damage and/or injury.
The product can be damaged if used in frost.
No maintenance work necessary.
Wind resistance class 1 = Beaufort wind scale
4 = 20‒27 Km / h (branches move, loose paper
is lifted from the ground)
Assembly
Use a cross-head screwdriver to attach the wall
brackets
to the product using the screws
5
(see Fig. A).
Choose a suitable installation area on a wall
and mark four holes for the brackets
Make 5 cm deep holes at the marked points
using a drill (see Fig. B).
Important: Make sure that the anchor bolts
are suitable for the material used. If they are
not, enquire about suitable anchor bolts at a
hardware store.
Attach the product to the wall by driving the
anchor bolts
into the drilled holes using a
7
hammer. Securely tighten the anchor bolts
using a spanner.
Choose a suitable installation area on the floor
and mark four holes for the fixing post
choosing the location, make sure that the posi-
tions of the cassette
1
are aligned horizontally. The fixing post
be installed at a maximum of 350 cm away from
the cassette
. Make 5 cm deep holes at the
1
marked points using a drill (Ø 8 mm) (see Fig. C).
Secure the fixing post
4
bolts
into the drilled holes using a hammer.
7
after you have
2
. Only release
4
.
1
can
2
6
.
5
7
. When
4
and the fixing post
4
can
4
by driving the anchor
Securely tighten the anchor bolts
spanner.
Opening the screen (see Fig. D)
Hold the handle
2
post
.
4
Insert the catch
3
the recess provided on the fixing post
Insert it into the catch
Closing the screen (see Fig. D)
Hold the handle
2
Follow the groove to disconnect the handle
and the fixing post
Hold the handle
2
cassette
. Move the handle
1
horizontally. The fabric will retract into the cas-
sette
by itself.
1
Cleaning and care
Allow all the parts to dry thoroughly before
you put the product away again. This will pre-
vent the formation of moulds, odours and dis-
colouration.
Clean the product with a slightly dampened,
lint-free cloth.
Always keep the product dry and clean at
room temperature.
Disposal
The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
using a
7
and pull it to the fixing
(under the handle
) into
2
.
4
on the fixing post.
8
, pull it back, and lift it.
.
4
and move it back to the
slowly and
2
GB/IE
2
9
Publicidad
Tabla de contenido
