Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
This product is not a toy and should only be
used under adult supervision.
Check the product for damage or wear before
each use.
Do not use the product close to a naked flame.
We recommend that two persons assemble the
product together in order to avoid injuries or
damage to people or the product.
Do not release handle
stand
, until it is fixed in the casket
4
Releasing handle
without attention may
2
result in damage and / or injury.
The operation in frosty conditions may damage
the product.
There is no maintenance required by the user.
Wind resistance class 1 = wind beaufort scale
4 = 20-27 km/h (small branches start to move,
loose paper is lifted)
Assembly instructions
Use cross screwdriver for fixing the brackets
on the product with screws
First locate a suitable installation position on a
wall and mark four hole positions of the brackets
(see fig. C).
5
Drill 5-centimeter-deep holes in the marked places
with a broach (see fig. D).
Important: Make sure before locating anchor
bolts are suitable for surface type. If not suitable,
consult your local hardware or DIY store.
Fix the product on the wall with the anchor
bolts
by hammering them into the pre-dril-
6
led holes with a hammer. Tighten the anchor
bolts
with a wrench (see fig E).
6
Locate the fixing stand
casket
and stand
1
4
aligned. Fixing stand
4
max. 300 cm from casket
the fixing stand holes and drill as per figure F.
Fix the stands
with the anchor bolts
4
hammering them into the pre-drilled holes with
a hammer. Tighten the anchor bolts
wrench (see fig F).
after removing from
2
.
1
5
(see fig. B).
7
position ensuring
4
are at same level and
can be mounted at
(see fig A). Mark
1
by
6
with a
6
Opening awning (see fig. G)
Hold the handle
2
stand
.
4
Insert the axis pin
3
into the axis pin hole on the top of stand
Insert the front bar
of stand).
Closing awning (see fig. H)
Hold the handle
2
(There is a groove to lock the handle
fixing stand
, so it is hard to pull up directly.)
4
and lift up.
Grasp the handle
2
Move the handle
2
The fabric will draw back itself into the casket
Cleaning and care
Allow all parts to dry thoroughly before you
pack the product up again. This will prevent the
formation of moulds, odours and discolouration.
Clean this product with a slightly dampened,
lint-free cloth.
Store the product in a sheltered room. Or always
store the dry and clean product at room tem-
perature.
Disposal
The packaging is made entirely of recyclable materials,
which you may dispose of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
and walk to the fixing
(under the handle
2
4
into the pin
(bottom
9
8
and pull back a little bit
and
2
and walk to the casket
slowly and horizontally.
GB/IE
)
.
.
1
.
1
9
Publicidad
Tabla de contenido
