Introduction; Unpacking And Checking Carton Contents; Tools Required - RIDGID WD1850 Manual Del Usuario

SP652816Gallon.qxd 5/12/06
The operation of any utility vac or blower
can result in foreign objects being blown
into the eyes, which can result in severe
eye damage. Always wear safety goggles
complying with ANSI Z87.1 (or in Canada
CSA Z94.3) shown on package. Everyday
eyeglasses have only impact resistant
lenses. They are not safety glasses.
Safety Goggles are available at many
local retail stores. Glasses or goggles not
in compliance with ANSI or CSA could
seriously hurt you when they break.
To reduce the risk of hearing damage,
WEAR YOUR

Introduction

This Wet/Dry Vac is intended for house-
hold use only. The Professional Wet/Dry
vac is supplied with a two stage/high
efficiency filter. It can be used not only to
pick up materials like sawdust and gravel
but also ultra fine material like drywall dust
and cold fireplace ash. Material that is so
small it would pass through traditional
filters.

Unpacking and Checking Carton Contents

Tools Required

Phillips Screwdriver
Refer to the assembly
positioning of parts.
11:45 AM Page 4
wear ear protectors when using the vac for
extended hours or when using it in a noisy
area.
For dusty operations, wear dust mask.
Use only extension cords that are rated for
outdoor use. Extension cords in poor
condition or that are too small in wire size
can pose fire and shock hazards. When
using an extension cord, be sure it is in
good condition. Using any extension cord
will cause some loss of power. To keep the
loss to a minimum, use the following table
to choose the minimum wire size
extension cord.
Extension Cord Length Gauge A.W.G.
FORESIGHT IS
BETTER THAN
NO SIGHT
Static Shocks Are Common - In dry
areas or when the relative humidity of the
air is low. To reduce the frequency of static
shocks in your home the best remedy is to
add moisture to the air with a console
humidifier.
Hammer
sketch for Remove contents of carton. Check each
item against the Carton Contents List.
Call 1-800-4-RIDGID (1-800-474-3443) or
E-mail us at info@ridgid.com if any parts
are damaged or missing.
4
0-50 Ft. 14
50-100 Ft. 12
IMPORTANT NOTE
Please Read Carefully
Mallet