Publicidad
Assembly
Prior to assembly, lay out all components and hardware as listed in the Parts List section.
1
Slide the Control Box
G
You will find the Center Rails
D
2
Place one of the Legs
A
holes on the Leg with the holes on the Frame End (Control Box).
Using the supplied 4 mm Hex Key, insert four (4) M6 x 10 Machine Screws
tighten to secure.
Repeat this step for the other Leg and Frame End
3
Slide the Side Bracket
F
Using the supplied 4 mm Hex Key, tighten screws to secure.
Note: For this step, the Frame End (Control Box) should be placed on the side of the desk where you plan to mount the Control Box and Handset.
Repeat this step for the other Frame Leg/End Assembly.
off the Frame End Assembly and set aside. Fully separate Frame End
inside.
E
D
G
into the Frame End (Control Box)
D
.
into the Frame End (Control Box)
C
E
ensuring the bar (arrow) is on "top" in relation to the Leg. Line up the
C
through the holes in the Frame End (Control Box) and
K
K
C
A
. Under the Frame End/Leg Assembly, insert two (2) M6 x 14 Screws
C
C
F
L
4
D
from Frame End (Control Box)
C
K
C
.
.
L
Publicidad
Capítulos
