Publicidad
Assembly
9
Using an assistant or mechanical lifting equipment, grasp the Desk Base Assembly (do NOT lift the desk top) and turn the desk right-
side up. Adjust the preinstalled leveling feet to stabilize the desk on uneven floor surfaces.
When lifting or moving the desk, do not lift from the desktop; always lift the desk from the WorkWise desk base.
10
Plug the Power Cord into a 110-120V power outlet.
Handset Panel
A
LED Display: Measures desk height in ±0.1 inch increments.
B
Up/Down Buttons: Adjusts desk to the desired height.
C
Height Preset Buttons: Automatically adjusts desk to a custom configured height.
D
Memory Button: Used to set height presets.
Operation
Prior to operating, make sure no obstacles are in the desk's path, the desk top is not touching any walls, and all cords
are appropriate length to accommodate the change in height.
Resetting the Handset
IMPORTANT: The desk's Handset must be RESET prior to first use.
To reset the Handset, press and hold the DOWN button until the desk reaches its lowest height.
Release the DOWN button. Then press and hold the DOWN button again until the LED display reads "RST". Again release the DOWN button.
Once more, press and hold the DOWN button until the desk lowers a little bit more, slightly rises and stops. Release the DOWN button one
final time. The Handset has been properly reset and the desk is now ready to use.
Adjusting Desk Height
The desk base can be adjusted by pressing and holding either the UP or DOWN button until the desired height is reached.
A
B
C
8
D
Publicidad
Capítulos
