Creating Height Presets; Adjusting The Led Display Height; Setting The Upper And Lower Limits - Tripp-Lite WorkWise Manual Del Propietário

Operation

Creating Height Presets

The desk's Handset is programmable for up to four presets. To create a preset, use the UP and DOWN buttons to find a desired height, then
press the button followed by Preset buttons 1 through 4.
CAUTION: Once a preset button is pushed, the desk will move to the programmed height.

Adjusting the LED Display Height

Press the DOWN button on the Handset until the base reaches its lowest position. Measure the height of the base from the floor. If the
number on the LED display does NOT match your measurement:
1. Press and hold the DOWN button again until the LED display reads "RST".
2. Press and hold the button for about 5 seconds. The LED display will flash the starting height.
Note: If the display returns to "RST" before the next step is taken, repeat this step.
To change the starting height values:
Height Value (in inches)
Increase Height
Decrease Height
Once the new value is displayed, wait about 5 seconds for the display to return to "RST". Finish the reset process by pressing and holding
the DOWN button again until the desk lowers a little bit more, slightly rises and stops. Release the DOWN button. The new starting height
value is saved and the desk is now ready to use.
Note: The LED display has a ±0.1 inch tolerance.

Setting the Upper and Lower Limits

This base is designed to go to its minimum and maximum heights, allowing for the widest possible range. If changing the settings to a more
narrow range is preferred, make sure the power is ON and a number reads in the LED display (if no number appears, please follow the reset
procedure described in the Resetting the Handset section).
A reset procedure requires the desk base to fully retract beyond any lower limit set. Always ensure there is proper
clearance below the desk base.
To Set the Upper-limit Position:
Use the UP/DOWN buttons to move the base to the desired maximum height position. Make sure the UP button was the last button
pushed. Press and hold the
succession. The LED display will change to "999" on the third push and automatically return to the selected height. The new upper limit is
set.
To Set the Lower-limit Position:
Use the UP/DOWN buttons to move the base to the desired minimum height position. Make sure the DOWN button was the last button
pushed. Press and hold the
succession. The LED display will change to "000" on the third push and automatically return to the selected height. The new lower limit is
set.
To Remove the Upper/Lower-limit Positions:
Use the UP or DOWN button to move the desk to any new position. Press and hold the
Then press and release the button in succession until the display changes to "555" (ignore any interim readings). After a few seconds, the
display will automatically change back to the numbered height position. The upper and lower limits have been removed.
After the upper and lower limits are set, the previous memory positions (1, 2, 3, 4) may be outside the new range of movement. If so,
simply reset the memory positions. If attempting to revise a previously set upper or lower limit and it is outside of the existing range, first
remove the previously set upper/lower limits.
By 0.1
Press the UP button
Press the DOWN button
button until the LED display flashes "S -" once. Then press and release the button two more times in quick
button until the LED display flashes "S -" once. Then press and release the button two more times in quick
By 1.0
Press the "1" button
Press the "2" button
button until the LED display flashes "S -" once.
9
By 10.0
Press the "3" button
Press the "4" button