Hayward OPTIMA pH/ORP NEXT Serie Manual De Instalación página 11

Paragraph 4 – Setting the Maximum Flow Rate
Programming
+
PROG
Config.
Config.
Funct.
Delay ON
Off
CALDelay
Off
Language
English
Max Flow
P100%
Paragraph 5 – Setting the Power On Delay
Programming
+
PROG
Config.
Config.
Funct.
Delay ON
Off
Paragraph 6 – Setting the Calibration Delay
Programming
+
PROG
Config.
Config.
Funct.
Delay ON
Off
CAL Delay
Off
EM00136321
Max Flow
P100%
Max Flow
F160c/m
Allows you to set the maximum flow rate of the pump and
the programmed mode (% or frequency) is used as the
standard measurement unit when displaying the flow rate.
Press to access the item then press
value. Press
Allows you to set a pump operation delay at the start up of
the pump. This delay takes effect only if the pump is
switched off and then switched on by disconnecting the
power supply.
The delay can be disabled, Off (default) or can be set from 1
to 60 minutes.
With the delay enabled, during the set time the LED flashes
(1 sec On – 1 sec Off) and the display shows the countdown
in seconds. If the pump is in Stop mode the display shows
only the flashing LED. During the delay time the function can
be disabled by accessing the menu and setting the time to
Off.
Press to access the item, and then press
the value. Press
menu.
Allows you to set a pump operation delay after the probe
(Redox or pH) calibration
The delay can be disabled, Off (default) or can be set from 1
to 60 minutes.
With the delay enabled, during the set time the LED flashes
(1 sec On – 1 sec Off) and the display shows the countdown
in seconds. If the pump is in Stop mode the display shows
only the flashing LED. During the delay time the function can
be disabled by accessing the menu and setting the time to
Off.
Press to access the item, and then press
the value. Press
menu.
rev.2.0 EN
Operation
to confirm and return to the main menu.
Operation
to confirm and return to the main
Operation
to confirm and return to the main
to set the
to set
to set
9