Hayward OPTIMA pH/ORP NEXT Serie Manual De Instalación página 12

Paragraph 7 – Flow Rate Calibration
Programming
+
PROG
Config.
Pump Cal
0.25cc/l
Pump Cal
Manuale
Pump Cal
Automat.
Paragraph 8 – Statistics
Programming
+
PROG
Config.
Stats
Hours
Hours
0
Strokes
0
Q.tu (L)
L 0
Power
1
Reset
Stats
Hours
Paragraph 9 – Password
Programming
+
PROG
Config.
Password
****
Password
0000
EM00136321
cc/s
0.25
Auto Cal
Start
cc
25
Reset?
Yes
On the main menu appears the memorized cc/stroke value.
You can perform the calibration in two modes:
MANUAL – insert manually the cc/stroke value using the
key and then confirm with the
AUTOMATIC – the pump runs 100 strokes, which are
started by pressing the
strokes insert the amount aspirated by the pump using the
key and confirm with the
The data entered will be used for the calculation of the flow
rates.
On the main menu is displayed, in hours, the operating time
of the pump; press
- Strokes = the number of strokes performed by the pump
- Q.ta (L) = the quantity dosed from the pump expressed in
liters; this information is calculated based on the memorized
cc/stroke value
- Power = the number of pump activations
- Reset = press
(NO), then press
Press to return to the main menu.
By setting the password, the programming section can be
accessed to view all the setup parameters, but every time
you try to change the settings you will be prompted for the
password.
The flashing line indicates the editable number; press
to select the number (from 1 to 9), then press
the number to modify, and then press
By setting "0000" (default), the password will be eliminated.
rev.2.0 EN
Operation
key.
key, and at the end of the
key.
Operation
to access other statistics:
to reset the counters, select (YES) or
to confirm.
Operation
to confirm.
to select
10