Symptoms
Appliance does not
operate.
Buttons may not
function properly.
Door does not open.
Appliance is not filling
properly.
42
Controls are not set properly.
• Make sure that the cycle should be correctly set. Close the door and press
the Start/Pause button.
Door is open.
• Close the door and make sure that nothing should be caught under the
door preventing it from closing completely.
Circuit breaker/fuse is tripped/blown.
• Check house circuit breakers/fuses. Replace fuses or reset breaker. The
appliance should be on a dedicated branch circuit. The appliance will
resume the cycle where it stopped once power is restored.
Control needs to be reset.
• Press the Power button, then reselect the desired programme and press
the Start/Pause button.
Start/Pause was not pressed after a cycle was set.
• Press the Power button, then reselect the desired programme and press
the Start/Pause button. The appliance is turned off if the Start/Pause
button is not pressed within 15 minutes.
Extremely low water pressure.
• Check another tap in the house to make sure that household water
pressure should be adequate.
Appliance is heating the water or making steam.
• The drum may stop operating temporarily during certain cycles, while
water is safely heated to a set temperature.
The door cannot be opened for safety reasons once the appliance starts.
• Check if the CL is illuminated. You can safely open the door after the H
icon turns off.
The door cannot be opened for safety reasons once the appliance starts.
• Check if the H icon is illuminated. You can safely open the door after the
H icon turns off.
Filter clogged.
• Make sure the inlet filters on the fill valves are not clogged.
Inlet hoses may be kinked.
• Check that inlet hoses are not kinked or clogged.
Insufficient water supply.
• Make sure that both hot and cold water taps should be turned on all the
way.
Hot and cold inlet hoses are reversed.
• Check inlet hose connections.
Possible Cause & Solution
EN