Defiant DFI-5852-BK Guía De Uso Y Cuidado página 9

Operation (continued)
4
Adjusting the SENS control
□
To increase the sensitivity, turn the "SENS"
control counterclockwise.
□
To decrease the sensitivity, turn the "SENS"
control clockwise.
NOTE: The motion sensor (C) is more sensitive to motion
moving across the front of the sensor. The motion sensor
(C) is less sensitive to motion moving directly toward the
front of the sensor.
NOTE: The higher the "SENS" setting (sensitivity), the
greater the possibility of false triggering. To reduce false
triggering, turn the "SENS" control clockwise.
5
Adjusting the TEST / TIMER
control
NOTE: The "Test / Timer" control determines the amount
of time the light will stay on full bright after all motion
has stopped.
□
After all adjustments are complete, turn the
"Test / Timer" control clockwise and select
a time between 10 seconds (10S) and 10
minutes (10Mins). The light will only work at
night after a time has been selected.
6
Switching motion detection
OFF and ON
NOTE: This light fixture can operate as a motion detection
light (default from the factory) or as a dusk-to-dawn
(nighttime) light. The wall switch controlling the light is used
to select the desired mode. In either mode, the light will only
operate at night.
IMPORTANT: THIS LIGHT FIXTURE MUST BE WIRED
THROUGH A WALL SWITCH IN ORDER TO USE THE
MOTION OFF FEATURE. IF THE LIGHT FIXTURE IS
WIRED DIRECTLY TO THE HOUSE WIRING WITH NO
WALL SWITCH, THEN THE MOTION OFF FEATURE
CANNOT BE SET.
To switch between modes:
□
Ensure the power to the light is ON and the
sensor has warmed up (60 seconds).
□
Switch the power OFF–ON–OFF–ON at the wall
switch within 3 seconds.
The light will stay in the selected mode until the above
steps are performed again.
C
□
To increase the time, turn the "Test / Timer"
control clockwise.
□
To decrease the time, turn the "Test / Timer"
control counterclockwise.
C
IMPORTANT: IF THERE IS A POWER OUTAGE OR THE
WALL SWITCH TO THE LIGHT FIXTURE IS TURNED
OFF FOR MORE THAN 5 SECONDS, THE LIGHT WILL
DEFAULT TO THE LAST SELECTED MODE SETTING IT
WAS SET TO BEFORE THE POWER OUTAGE.
OFF ON
Less than 3 seconds
NOTE:
• If motion detection mode is set to ON, the red LED behind
the motion sensor lens will blink indicating motion has
been detected.
• If motion detection mode is set to OFF, the red LED behind
the motion sensor lens will not blink.
9
Please contact 1-866-308-3976 for further assistance.
OFF ON
HOMEDEPOT.COM