Philips HQ8290CC Manual Del Usuario página 16

ENGLISH
18
4222.002.4998.2.indd 18
,
During the second phase of the cleaning
program, the shaver is placed in the drying
position, indicated by a flashing drying symbol.
This phase takes approx. 4 hours. The shaver
stays in this position until the end of the
program.
,
After the cleaning program, the battery symbol
on the Jet Clean System goes on to indicate that
the shaver is being charged.
Note: If you press the on/off button of the Jet
Clean System during the cleaning program, the
program aborts and resets. In this case, the cleaning
or drying symbol stops flashing and the holder returns
to its starting position. The shaver may still be wet
and dirty, because the cleaning program has not been
finished.
Note: If you remove the adapter from the wall socket
during the cleaning program, the program aborts. The
holder remains in its current position. When you put
the adapter back into the wall socket, the holder moves
to the highest position.
- When the fluid level drops below the minimum
level, the cleaning symbol and the 'fluid low'
symbol start to flash with intervals and the holder
returns to its starting position.
Cleaning the Jet Clean System
Empty the cleaning chamber and clean it thoroughly
by rinsing it with hot tap water every 15 days if you
use the Jet Clean System daily. Otherwise empty and
clean the cleaning chamber at least once a month.
1 Clean the outside of the Jet Clean System with
a moist cloth.
27-02-2009 11:34:21