Inserting The Battery - Bushnell TOUR X Manual De Instrucciones

INSERTING THE BATTERY

Remove the Posi-Thread™ battery door by lifting the battery door tab and then rotating counter clockwise.
Insert a CR2 3-volt lithium battery into the compartment negative end first, then replace the Posi-Thread™
battery door.
Note: It is recommended that the battery be replaced at least once every 6 months.
ACTIVE LASER
Crosshairs surrounding the aiming circle indicate that the laser is being transmitted. Once a range has been acquired,
you can release the power button. The crosshairs surrounding the circle will disappear once the power button has been
released (i.e. the laser is no longer being transmitted).
PINSEEKER WITH JOLT
™ ®
Ever have trouble getting distance to the flag? This advanced mode allows easy acquisition of the flag without
inadvertently getting distances to background targets (i.e. trees) that have stronger signal strength.
For ease of use, the device will always be in PinSeeker Mode.
™
To use, align the aiming circle reticle onto the flag that you want distance to. Next, press and hold the POWER button
and move the laser slowly over the flag or desired object until a circle surrounds the flag indicator. If the laser beam
recognized more than one object (i.e. flag and background trees), distance of the flag will be displayed and a circle will
surround the PinSeeker™ indicator informing the user that distance to the flag (i.e. closer object) is being displayed.
The Jolt Technology provides two short bursts of vibration to confirm that the distance displayed is to the flag. There
may be times when only the laser beam only sees one object in its path. In this case, the distance will be displayed, but
because more than one object was not acquired, a circle will not surround the flag indicator.
Tip: While pressing the POWER button, you can move the device slowly from object to object and intentionally force the laser to hit multiple objects to ensure that
you are only displaying the closest of the objects recognized by the laser. Once the device has shut off, the unit will always default back to the last mode used.
7