Battery Life Indicator; Inserting The Battery - Bushnell Elite 1 Mile CONX Manual Del Usuario

Gun 1-3 Mode ( , etc): These are three custom rifle modes which allow you to create a ballistic curve that is specific
for a caliber and load combination (along with other parameters) and then store that in the rangefinder's memory.
These custom ballistic curves can be setup by using the Bushnell CONX App along with an online ballistic calculator,
then saved to the rangefinder. See page 22 for more details. Note: in the App, these are referred to as "Custom 1-3" rather
than Gun 1-3.
): In this mode, the rangefinder sends the distance and angle to a compatible Kestrel device. The
AB Mode (
Kestrel device calculates a holdover based on environmental conditions at your position and sends the holdover value
back to the rangefinder. Model # 202540KC owners only: see the provided Kestrel instructions for more details.

BATTERY LIFE INDICATOR

Full charge
2/3 battery life remaining
1/3 battery Life remaining
Battery Indicator Blinks - Battery needs to be replaced and unit will not be operable.

INSERTING THE BATTERY

Remove the battery cap by lifting the battery door tab and then rotating counter clockwise. Insert a CR123 3-volt
lithium battery into the compartment negative end first, then replace the battery cap.
NOTE : It is recommended that the battery be replaced at least once every 12 months.
UNIT OF MEASURE OPTIONS
1 Mile CONX
The Elite can be used to measure distances in yards or meters. The unit of measure indicators are
located in the lower right portion of the LCD.
9