Default Values - Conceptronic C54PSERVUM Manual De Usuario

ENGLISH
Do not attempt to disassemble the included power adapter. This may cause high-voltage
injuries. If the adapter needs to be fixed, please contact your dealer or the
Conceptronic helpdesk.
Keep the device away from excessive moisture.
Do not immerse in or expose to liquids.
Disconnect the power adapter if you do not intend to use the device for an extended
period of time.
Avoid using the device in a location near combustibles.
Never drop, shake or bump the device.
To prevent overheating, do not cover the device.
Do not use the device outdoors.
IP Address
Subnet Mask
Default Gateway
Note: This only applies when there is no DHCP Server in the network. When a DHCP
Server is present, the C54PSERVUM will get an IP address from the DHCP Server.
Username
Password
MF Printer Server name
Workgroup
The above values are factory default values for the C54PSERVUM. If you need to go back to
the factory default values, follow the instructions below:
A. Press and hold the INIT button on the C54PSERVUM (See chapter 4).
B. Disconnect and reconnect the power from the C54PSERVUM, while holding the INIT
button.
C. Hold the INIT button for 10 seconds, while the USB LED is blinking.
D. Disconnect the power, release the INIT button and reconnect the power.
The C54PSERVUM is now set back to the factory default values.
2. Notes & cautions

3. Default values

: 192.168.0.55
: 255.255.255.0
: 192.168.0.1
: admin
: admin
: C54PSERVUM
: Workgroup
16