Connections To Be Made; From The 22-Way Harness; From The 30-Way Harness - Axxess GMLAN11-100 Instrucciones De Instalación

Connections to be made

1. From the 22-way harness:

Connect the 3.5mm jack to the aftermarket radio's steering wheel control input (if equipped).
Note: If using Eclipse, Kenwood, or select JVC radios use the supplied female 3.5mm adaptor.
• For Kenwood and select JVC radios: Connect the SWC wire (normally Blue/
Yellow) to the Brown wire of the ASWC. Isolate and tape the Brown/White wire
because it will not be used.
Note: Some of the newer Kenwood radios will auto detect as a JVC. If this is the
case, you can use a 12k ohm resistor (included) in line between the Blue/Yellow
and Brown wire of the female 3.5mm jack during programming only. Or manually
set the radio type, refer to the radio programming section of this manual.
• For Eclipse: Connect the Eclipse SWC wires (normally Brown and
Brown/Black) to the Brown and Brown/White wires of the ASWC. Brown goes
to Brown and Brown/White goes to Brown/Black. Sometimes this is reversed,
reverse the wires if needed.
• For Metra OE radios: Connect the SWC Key 1 wire (Gray) to the Brown wire
of the ASWC.
For all other radios, plug in the male 3.5mm connector of the ASWC into the back of the
aftermarket radio designated for an external SWC control interface.
Please refer to the aftermarket radio manual if in doubt where the 3.5mm connector of the
ASWC should go.
The Black/Yellow wire is not used in this application.

2. From the 30-way harness:

• Connect the Black wire to the ground wire of the aftermarket radio.
• Connect the RCA's to the AUX in on the aftermarket radio (if equipped).
• Connect the Yellow wire to the constant wire of the aftermarket radio.
• If the vehicle is amplified disconnect the 4-pin harness located between the 30-way
and 22-way connector and connect the supplied 4-pin to 4-pin resistor pad. If the
vehicle is not amplified connect the two 4-pins for the 30 and 22-way together.
Continued on next page
GMLAN11-100
4