Remington PowerClean MS-900 Guía De Uso Y Cuidado página 6

How To Use
Operating the Cleaning
System
Cleaning
To activate cleaning mode, simply
press the CLEAN button on the clean-
ing base. The amber indicator light
flashes through the entire cleaning
cycle, which lasts approximately 2
minutes. When the cleaning cycle has
been completed, the amber light will
stop blinking and glow steadily. The
unit then returns to charging mode.
! Wait until the cleaning cycle
has finished before removing the
shaver from the base. If the shaver is
removed during the cleaning cycle it
will be covered with cleaning solution
and be unusable.
Shaver should be left in cleaning base
for about 24 hours to allow it to dry
for next usage.
Solution levels
The cleaning solution will slowly
evaporate with use. When the solution
levels get low, the red replacement
indicator light will begin to flash.
This means you have enough clean-
ing solution left for approximately 5
more cleanings. If the red light stops
blinking and glows steadily, the unit
will not operate until the solution and
filter have been replaced.
Replacing the Filter and Solution
Only Remington's special cleaning
solution and filter can be used with
the Smart System. The cleaning
solution contains a high percent-
10
32651_MS-900 IB.indd 10-11
age of alcohol and a special oil that
lubricates your shaver each time
it is cleaned. The filter is specially
designed to collect hair debris yet
allow for the system to clean your
shaver.
Remove and discard filter and empty
any remaining cleaning solution.
Rinse unit tank then let dry. Fill with
fresh solution, insert new filter and
replace upper portion.
Wipe off the unit periodically with
a damp cloth and remove any hair
debris that has collected where the
shaver sits.
! To avoid damage to the cleaning
system, use only Remington's special
cleaning solution.
Remington's replacement solution
and filter is model #CC-100. U.S.
residents: To order, contact us at
(800) 231-8793,
www.remington-products.com, or
visit your local retailer.
Canadian residents: For shaver
accessories, call (800) 268-0425.
To Charge Your Shaver
The MS-900 can also be recharged
by plugging into the cord directly.
■ Use only the charging adapter
supplied with the shaver.
■ Make sure your shaver is turned
off.
■ Connect the cord to the shaver,
then plug the charging adapter into
the electrical outlet. A charging
indicator light will come on.
■ Your shaver cannot be
overcharged, so you can leave it
plugged in and charging between
shaves.
■ To preserve the life of the batteries,
let them fully run out every six
months, then recharge them for a
full 24 hours.
■ Cord/cordless rechargeable
shavers can run directly off the
cord if necessary. They will not
recharge while you are shaving,
so after shaving with the cord,
turn the unit off and set it aside
to charge. Cord/cordless shavers
should not be used strictly as cord-
operated shavers, as continued
cord-only use will result in
reduction of battery life.
■ Quick Charge provides up to 60
minutes of shaving after a one-
hour charge, or a single shave
after a five-minute charge.
NOTE: If your shaver battery is
completely discharged or the shaver
has not been used for a long time,
the shaver may not start when oper-
ated using the cord. If this happens,
charge the shaver for approximately
five minutes before shaving.
Removing the
Headguard
Before operating your
shaver, remove the
headguard, which pro-
tects the screen and
cutter assembly. Simply push up from
the front or the back until it pops off.
! Always keep the protective head
guard on the shaver head and keep
the trimmer in the OFF position when
the shaver is out of the cleaning base
and not in use.
Operating the Trimmer
Your shaver is
equipped with a
3-position trimmer.
Use the trimmer
button to extend or
retract the trimmer.
1. Completely retracted (down), the
trimmer is out of the way and
off, for when you want to use the
screens alone. Slide the trimmer
button down with your thumb to get
it into this position.
2. In the middle position, the trimmer
works with the screens, cutting the
longer, hard-to-shave hairs so the
screens can get in extra close. Slide
the trimmer button into the position
level with the foils.
3. Fully extended (up), the trimmer
can be used to trim your sideburns
and mustache. Slide the trimmer
into the top position, above the foils.
11
2/19/07 2:09:21 PM