Waring Commercial LIQUILOCK WFP16SCD Manual De Instrucciones página 11

JULIENNE DISC OPERATION
Waring Commercial offers a julienne disc as an optional accessory.
Follow the instructions below to operate.
• Prepare all food items to be processed by washing and peeling
as required. Remove pits, stones, and large seeds. Be sure the
food will fit into the proper feed chute.
• If a long horizontal cut is desired – for example, squash sticks –
the food must be placed in the feed chute horizontally or on its
side. For finely chopped food results – for example, chopped
celery or finely chopped onions, you must insert the vegetables
vertically or standing up. For a very fine chop of onions, quarter
the onion and gravity-feed it through the chute.
Removing processed food from the batch bowl
1. Turn the machine off and wait for the blade to stop moving
before removing the lid and pusher.
2. If the blade holds the bowl locked when the motor stops,
move the handle of the bowl rapidly back and forth – first
clockwise, then counterclockwise.
3. If using a disc, remove before tilting the bowl, using a spatula
to scrape off any food sticking to it. If using S-blade, it will
stay locked in the bowl when you tilt to pour. Use spatula
to scrape food out of bowl. NEVER USE FINGERS TO
REMOVE FOOD WHILE BLADE IS IN BOWL.
TROUBLESHOOTING
This section describes potential problems and the correct
solutions for them. Problems that cannot be solved with the
guidelines listed below should be referred to one of the Waring
Authorized Service Centers for assistance. A listing of authorized
service agencies is supplied with each Waring food processor.
Unit does not start when assembled correctly
• Pull the plug and try plugging into another outlet.
• Make sure the bowl is properly positioned on the motor base,
that the bowl cover is attached properly, and that the safety
interlock tab on the cover has properly engaged the safety
interlock switch.
• Press ON button.
20
Unit stops running during processing
• The unit may have overheated. Refer to Resetting Thermal
Protection section (page 15).
• Turn unit off and unplug.
• Remove bowl attachment.
• Remove food being processed from inside the bowl and discard.
• Allow unit to cool for 30 minutes.
• Reassemble unit, and run first with the bowl empty, then put
food into the bowl and try again.
Unit jams or vibrates excessively
• Turn unit off and unplug.
• Disassemble the batch bowl/accessories.
• Make sure there is no food in S-blade hub (if applicable).
• Clean food off accessory discs (if applicable).
• Reassemble unit, and run first with the bowl empty, then put
food into the bowl and try again.
Unit will not come up to full speed
• Bowl is overloaded – remove food being processed and reload
using smaller quantities.
If unit does not operate after you have followed the above
• Check outlet to be sure there is current.
• Check to be sure circuit breaker is on.
• Check to be sure the fuse is not blown if there are fuses on this
circuit.
• Call a local Waring service agency.
If food processor makes grinding noise
• Turn unit off, unplug, disassemble, check bowl and blade to see
if they have been rubbing together.
• If bowl and blade are rubbing, call your authorized Waring
service agency.
21