Safety Information; Safety Warnings; Preliminary Recommendations; General Information - WEG CFW100 Guía De Instalación, Configuración Y Operación

1 SAFETY INFORMATION

1.1 SAFETY WARNINGS

NOTE!
Only use the remote serial HMI
„
(CFW100-KHMIR) on WEG CFW100
series inverters.
It is recommended reading the CFW100
„
user's manual, as well as the installation,
configuration and operation guide of
the RS485 (CFW100-CRS485) before
installing or operating this accessory.
T he conte nt of this guide provide s
„
i m p o r t a n t i n f o r m a t i o n f o r t h e f u l l
understanding and proper operation of
the remote serial HMI.
NOTE!
In order to check the firmware version of
„
this accessory, press and hold the "P" key
for over three seconds.

1.2 PRELIMINARY RECOMMENDATIONS

ATTENTION!
Always disconnect the general power
„
supply before connecting or disconnecting
the accessories of the CFW100 frequency
inverter.
Wait for at least ten minutes for the full
„
discharge of the inverter.

2 GENERAL INFORMATION

This guide provides directions for the installation,
configuration and operation of the Remote serial HMI
(CFW100-KHMIR).
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Remote Serial HMI