Phono - auna NR-620 DAB Manual Del Usario

PHONO

• Remove the stylus protector.
• Be sure that the tone arm is being detached from the tone arm rest
before operating and re-secured again afterwards.
1. Press the Power on/off / Function button (13) to turn on the unit and
press the button again to switch the function to PHONO mode.
2. Set the speed selector to the proper position depending on the record
to be played.
3. Place the record on the platter (use the spindle adaptor if required).
4. Lift the tone arm from the rest and slowly move it to the record side.
The platter will start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume (9) to the desired level.
7. At the end of record, the platter will automatically stop rotating. Lift the
tone arm from the record and return it to the rest.
8. To stop manually, lift the tone arm from the record and return it to the
rest.
Remark : As some kind of record the auto-stop area was out of the unit
setting, so it will stop before the last rack finish. In this case, select the auto-
stop switch (24) to " off " position, then it will run to the end of the record
but will not stop automatically (turn off the unit by power button or switch
back the auto-stop switch to " on " position to stop the platter rotate). Then
put back the tone arm to the rest position.
EN
37