D-Link DP-300+ Guia De Instalacion página 3

Connecting the DP-300+ to Your
Network
Note: Don't connect the power cord to the DP-300+ until you are advised to do so.
For Mac OS printing, please refer to manual (.pdf) located on the CD-ROM.
A. Insert one end of a straight-through CAT5 Ethernet cable into the DP-300+'s LAN Port.
Connect the other end to an Ethernet port on your gateway or switch.
B. Make sure that your Printer is turned OFF.
C. Attach one end of your printer cable to the appropriate port on the DP-300+ and the
other end to the corresponding port on your printer.
D. Turn ON the printer. Repeat steps B-D for each printer before proceeding to step E
E. Plug one end of the power adapter into the DP-300+ and the other end into your electric
outlet. The DP-300+ will turn on and begin a self-test.
Configuring the DP-300+
For additional Windows operating system setup or information on the
Web-management interface, refer to the manual located on the CD-ROM.
The factory default IP address of the DP-300+ is 192.168.0.10. The IP address of the
DP-300+ must be in the same range as your network. You can change the IP address
of the DP-300+ to match the IP address scheme of your existing network. To access
the Print Server's Web configuration interface, assign an IP address on one of the wired
PCs on your network to the same IP scheme as the Print Server.
Go to Start > Right-click on
My Network Places
Right click on the Network Connection
associated with your Network Adapter and
select Properties.
Click Internet Protocol (TCP/IP)
Click Properties
(continued)
> select Properties >
3
.