Base Assembly - Honeywell QUIETSET HS-1650 Serie El Manual Del Propietario

ASSEMBLY INSTRUCTIONS
Blade Knob (D)
Clips (G)
Front Grille
A. Base Assembly
• P lace base on a flat surface
• Fit bottom of Metal Fan Pole (A) into circular recess in fan base (Fig.2).
B. Securing the Fan Pole to the Base
• A lign 3 screw holes at the base of Metal Fan Pole (A) with the 3 holes at the base.
• Secure the Metal Fan Pole to the base by inserting and tightening the 3 screws in
the 3 holes on the bottom of the base (Fig. 2).
• Slide the Pole Base Cover into place in the base and turn COUNTER-CLOCKWISE
until it snaps securely into place.
C. Determining the Height of the Fan
• Turn the Height Adjustment Knob (B) in a COUNTER-CLOCKWISE direction so that
the Knob loosens around the Metal Pole Extension.
• Pull the Metal Pole Extension out of the Metal Fan Pole to the desired height.
• Turn the Height Adjustment Knob (B) in a CLOCKWISE direction to tighten and
secure the Metal Pole Extension into place at the desired height.
Fig. 1
A
B
Metal
Height
Fan
Adjustment
Pole
Knob
Fan Blade
Fig. 2
Metal
Pole
Screws
Rear Grille
Mounting
Nut (E)
Rear Grille (F)
Base
A
Metal
Fan
Pole
Motor
Assembly (C)
Control
Panel
Metal Fan Pole (A)
Height Adjustment
Knob (B)
Metal Fan Pole (A)
Pole Base Cover
3