Motor Assembly; Bulb (X 3); Blade Washer (X 15); Blade Arm (X 5) - Honeywell 50614 Guia Del Usuario

FINAL INSTALLATION
4. Partially insert the blade screws along with lock washer and blade washer through blade and into the blade arm. Tighten each
blade screw starting with the one in the middle (Figure 5.4). Repeat this step for the remaining blades and blade arms (Figura 5.4).
5. Remove the 10 motor screws from the underside of the motor assembly. Then, install the blade arms to the underside of the
motor assembly using the ten previously removed motor screws (Figure 5.5).
6. Remove one of the three fitter plate screws from the fitter plate and loosen the other two. Then, connect the 9-pin connector
from the fan to the 9-pin connector from the light kit (Figure 5.6).
7. Lift the light kit and place the two keyhole slots in the light kit over the two loosened fitter plate screws. Turn the light kit
clockwise and secure it to the fitter plate with the previously removed fitter plate screw. Tighten all three screws (Figure 5.7).
8. Install the three E26-base bulbs into the sockets of the light kit (Figure 5.8).
9. Remove the battery cover from the back of the remote and insert the 12-volt battery, noting polarity -- positive (+) to positive
(+) and negative (-) to negative (-). Replace the battery cover. If battery is installed correctly, the LED indicator on the front of
the remote transmitter should illuminate when any button is pushed (Figure 5.9).
Blade Screw
Blade Washer
Blade Arm
Figure 5.4
Keyhole
Slot
Fitter Plate Screw
Figure 5.7
Blade
Motor Screw
Figure 5.5
Figure 5.8
Blade Arm
Figure 5.6
Bulb
Figure 5.9
7
9-pin Connector
Battery
Cover
Battery