En.7.2.2 Micro Filter; En.7.2.3 Exhaust Filter; En.7.3 Changing The Power Cable; En.7.4 Spares And Accessories - Tennant 3400 Instrucciones Para El Servicio

Hold onto the tab of the filter bag trap door and gently
pull upwards. This will automatically close the trap
door (preventing any dust from escaping) and the bag
will slide upwards and out of the tank.
The new paper filter bag may now be installed. Simply
locate the cardboard edges of the paper bag mounting
plate into the locating grooves in the tank and slide the
bag down into position.
The suction hose coupling may now be reinserted into
the tank socket -- hold the rubber cuff, insert the
coupling and lock into position by rotating clockwise.
(10- -05)
Home Find... Go To..

EN.7.2.2 Micro Filter

The micro filter (1) is secured in position above the
motor by means of a simple press fitting. Two
recesses, in the mounting column, above the cartridge
filter, on the left and right sides, allow you to insert the
middle fingers of both the left and right hands and
gently pull upwards on the underside of the cartridge
filter. To replace the new or cleaned cartridge simply
push it gently downwards onto the mounting column.

EN.7.2.3 Exhaust Filter

The exhaust filter (2) is designed to primarily filter the
carbon dust from the carbon brushes of the motor. It is
situated on the front of the machine, in the chassis,
under the tank socket. Pull the filter outwards by firmly
holding onto the black plastic tab/handle. Open the
filter gate/frame which now exposes the filter fleece.
Replace the fleece, close the frame and reinsert it into
the machine. The exhaust filter should be changed at
least every six months.

EN.7.3 Changing the power cable

The high quality power cable has conductor cross
sectional areas of 1 sq. mm and these conductors are
made up of many single strands. A damaged cable
can be easily replaced. After disconnecting the plug
from the main power supply, turn the machine over to
expose the chassis. Slide the plug retaining clip
forward and flip upwards to expose the plug. Remove
the old plug with cable and reinsert the new plug with
cable. Flip the retaining clip down and slide it back. A
click will be heard once it is in position.
For safety reasons only, genuine Tennant
spare parts should be used! Any unauthorized
opening of the appliance, technical modifications
or non- -original parts will annul the guarantee!

EN.7.4 Spares and accessories

Should you require spares, accessories or
consumables for your Tennant 3400, please contact
your Tennant distributor.
Tennant 3400
9