Warming Drawer - GE Advantium Serie Instrucciones De Instalación

Preparation
NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4 .
MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT
AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.
PREPARE THE OPENING (cont.)
The Advantium 120V can be installed in
combination with other GE/Monogram appliances.
Always follow each product's Installation
Instructions to complete the installation.
Single Advantium 120V Installation:
Order a 30 wide single oven cabinet or cut
the opening in a wall to the dimensions shown.
30
21
36-3/4
Min.*
case trim overlap on the sides,
1-1/16 overlap on the top and 7/8 overlap
on the bottom of the opening for all models.
of the opening.
When installed over a single oven or a warming
drawer, allow at least 2 between the two
openings. This separation will provide clearance
for bottom overlap of the Advantium 120V and the
other appliance overlaps.
Construct a solid oven floor of 3/8 min. thick plywood
supported by 2 x 4 or 2 x 2 runners on all sides.
flush with the bottom edge of the cutout.
Installation Preparation
WITH
23-1/2
25-1/4
Min.
Construct Base
Min. 3/8 Plywood
Supported by 2 x
4 or 2 x 2 Runners
all Four Sides
* Required for
Monogram models
an Accessory Storage Drawer
PREPARE THE OPENING (cont.)
Installation over a GE/Monogram

Warming Drawer:

30
21
36-3/4
Min.*
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth
and height. See Warming Drawer installation
instructions for details.
10
23-1/2
Construct Solid
Bottom Min. 3/8
25-1/4
Plywood Supported
Min.
by 2 x 4 or 2 x 2
Runners all Four
Sides
2 Min.
(3 Recommended)
Per Warming
Drawer
Requirement
* Required for
Monogram models