Altrad Belle BHB BREAKERS Manual Del Operador página 33

Check your Breaker and identify the P and T side of the body by looking for a
letter stamp on the large bung. This can be found on the side of the Breaker as
shown in the diagram. This stamp also corresponds to the Restrictor / Fitting on
the same side of the Breaker
For example: In the image the bung on the left hand side of the Breaker is clearly
Line and the right hand side will be the Tank / Return Line.
P = Pressure side of the Breaker
T = Tank / Return side of the Breaker
WARNING
BHB27, BHB27X & BHB30 USA ONLY!!
Restrictors / Fittings
Oil Flow Rate EHTMA Category
CAUTION
DO NOT attempt to change the Restrictor immediately after use as the Hydraulic Oil will be hot.
Replacing The Restrictor
Do not place it on the Nose Section because the Breaker can tilt.
4. Loosen the Restrictor on the Breaker. Remember to have an oil pan ready to take the oil spill from the Breaker.
NOTE:-
Matching The Breaker To The Power Pack
You must only ever change the TANK Line Restrictor / Fitting as you may cause harm to your Breaker
and Power Pack if the PRESSURE Line Fitting is changed.
Part Number
C
D
Restrictor Size
33
Restrictor /
Large
Notes
Fitted onto the Breaker