Altrad Belle BHB BREAKERS Manual Del Operador página 41

STARTING A CUT
working Breaker.
vibrations.
OPERATION
must absolutely not be pressed all the way down to the base.
vibrations.
WHEN TAKING A BREAK
activating the start and stop device.
EUROPEAN HYDRAULIC TOOL MANUFACTURERS ASSOCIATION CODE OF PRACTICE – HYDRAULIC BREAKERS
Before Starting. Refer to manufacturer's operating instructions.
Compatibility.
If in doubt consult the equipment manufacturer.
Characteristics.
Steel Selection It is essential that the correct type and size of steel is chosen if optimum performance is to be achieved, with
Material.
Concrete.
Tarmac.
Asphalt.
General Trenchwork.
ALWAYS USE SHARP STEELS -
Operating Instructions
EHTMA - Code Of Practice
Recommended Steel
Pointed or narrow bladed chisels.
Sharp edged wide bladed tools with straight cutting edges.
Sharp edged tools with thin section and curved cutting edges.
Spades and Digger steels.
41
A