Kohler K-3080 Guia De Instalacion página 8

Drawer lifts
out.
Model K-3081 shown
4. Secure the Cabinet/Vanity
NOTE: The drawer should be removed to finish mounting the
cabinet or vanity.
Remove the Drawer
Pull the drawer out to its full extension.
Tilt and lift the drawer upward in a continuous motion to release
the drawer from the drawer slides.
Mount the Cabinet or Vanity
Inside the cabinet or vanity, measure down 2-1/2" (6.4 cm) from
the inside top and 2" (5.1 cm) from each side. Mark the locations
on each side with a pencil.
Drill a small hole (smaller than diameter of a wood screw)
through the back of the cabinet or vanity and into the wall at the
marked locations. You should drill into the brace for proper
mounting.
Secure with 3" wood screws.
1011584-2-E 8 Kohler Co.