Complete The Installation - Kohler K-3080 Guia De Instalacion

5. Complete the Installation

NOTE: The cross gallery rail on the vanity (K-3081) is intended to be
in front of the P-trap to prevent items from interfering with the
drain. The cross gallery rail on the cabinet (K-3080) can be adjusted
to separate the drawer.
Pull the drawer slides out to full extension.
Familiarize yourself with the position of the clips on the
underside of each drawer slide.
Align the drawer onto the drawer slides. Allow for approximately
2" (5.1 cm) of clearance between the front of the drawer and the
end of the drawer slide.
Firmly hold the drawer open with one hand so that the drawer
remains fully extended.
Slide each clip tab toward the front of the drawer until each clip
clicks into place.
Close the drawer.
Kohler Co.
Slide should be
fully extended.
Drawer Slide
Pull clip tab until it
clicks into place.
9
2"
(5.1 cm)
1011584-2-E