Controls - Vornado V-Flow Guia Del Propietario

Power (A) The unit functions ON and OFF by pressing the
1
POWER button. Lights on the unit's control panel indicate the
power is ON.
Fan Speed (B) The fan speed can be adjusted by pressing the
2
SPEED button. Press the button to switch between the unit's
speed settings. The turbo (highest) setting is for maximum air
circulation (available on 154 and 184 only). Lights on the unit's
control panel indicate the selected speed setting.
Timer (C) The unit has an automatic timer to turn the unit OFF
3
at intervals of 1, 2, 4 or 8 hours. To set the timer, turn the unit
on and select desired speed. Press the timer button until the
desired run time light is illuminated. The unit will continue to
run until that amount of time has expired.
Models 184 and 154
feature 4 speed settings
Models 173, 153 and 143
feature 3 speed settings
Remote Control This unit comes with a remote control. The
4
remote control functions are the same as the control panel on
the unit. The remote requires a line-of-sight path to allow for
the signal to be received by the unit. Position the unit so the
receiver lens (located above the Vornado logo) is visible from
the remote control. The remote control can be stored with
the Tower Circulator using the magnetic bowl-shaped cradle
located on the top of the product.
Remote Control Battery The remote control comes with a 3
Volt lithium coin cell battery (CR2032). To install, remove the
battery cover on the bottom of the remote control. Remove any
plastic protection from the battery and place it in the remote
with the + side facing out. Then reposition the cover onto the
bottom of the remote. If your remote does not work, please try
replacing with a new 3 Volt CR2032 battery.
A
B
C

Controls

English 9